How To Paint Doors And Trim

Tape off the inside of the window panels using painters tape. Apply a second coat as necessary to achieve complete and uniform coverage.

Roof and wall trim.

How to paint doors and trim. If youre painting your trim indoors youll need to cut in the trim meaning carefully paint along the edge where the trim meets the wallfloor. Then wipe again to remove dust. Clean the door surface well.

Move each sash up and down daily for one week to prevent the window from sticking. Once you get all the needed tools and accessories then its time to actually start painting trim and doors. Finish your windows by painting the window trim top to bottom doing the edges first then the face of the trim.

Allow the caulk to dry for the amount of time specified on the label before applying a topcoat. Allow enough time for the paint to dry fully before putting doors and windows back into use. Brushes are best for applying paint to most trim.

Thoroughly wipe clean all the trim and door surfaces and allow them to dry thoroughly. I used benjamin moores aqua lock primer for this step. To maintain your beautiful doors and trim you may use behr swipes interior wall wipes after 4 weeks to quickly and easily wipe away dirt and common household stains.

Go back over the spots right where the tape is with a little more paint and the paintbrush then remove the tape immediately. How to paint trim and doors. Paint the trim first.

I dont think i realized how much actually goes into painting trim and doors. Keep your sashes open as described above until the paint has dried. Use a utility knife to score along the tape and paint then pull the tape up.

Wait several hours or days if using oil paint for your first layer to dry completely before moving onto the second coat. I lot of people dont know which one to paint first the trim or the walls. Check for cracks or holes in doors or trim.

Paint the center section of the trim after the edges. Otherwise they will stick together. After you prime bare wood apply caulk along all open seams between trimboards.

Prime the metal door and plastic trim. To increase paint adhesion lightly sand the surface with fine sandpaper. If you use a roller backbrush immediately with a wide brush or pad to smooth the roller stipple.

Prep the exterior door and plastic trim for painting. Here are the steps that i follow. Fill with putty as needed and then sand any rough areas.

The texture that rollers impart works well for walls and ceilings but isnt attractive on doors or wood trim. I always spray trims first then the walls. Whew that was a lot.

Rolling a flush flat door paint a flat door with a brush pad or roller with a 14 inch nap or foam sleeve. Remove door handles if you desire to or tape around them carefully with painters tape.

Interior Semi Gloss Cabinet Trim Enamel Paint Behr